Skip to content
Circle ACircle A
0

Red Wing Pecos Boots Guide: 1155, 2231, 2230, 3505 & 8060

Red Wing Pecos boots compared: the 1155 NailSeat, the 2231, 2230 and 3505 SuperSole pull-ons, and the 8060 Heritage Pecos. Toe, sole, waterproofing and how a pull-on should fit.

Quick answer: A Red Wing Pecos is an 11-inch pull-on boot. Pick the 1155 NailSeat for a soft toe and a leather welt with a heat-resistant cork sole. Pick a SuperSole (2231, 2230, 3505) for a steel toe, EH rating and a chemical-resistant urethane sole. The 2230 is the waterproof one. The 8060 is the western roper.

What is the Red Wing Pecos?

The Pecos is Red Wing's pull-on boot. Red Wing says it was first made for cowboys as a roper-style boot, and it spread well beyond the ranch. The Heritage 8060 Pecos still follows that original shape: an 11-inch shaft, an almond toe, a low heel and the No. 17 last.

On the work side, Red Wing lists its pull-ons under names like SuperSole and NailSeat. Most of our customers, and most of the oilfield, still call any 11-inch Red Wing pull-on a Pecos. That is how we use the word in this guide.

Every Pecos covered here has no laces. You step in, pull with the loops and go. That makes them quick to get on before a shift and quick to kick off at the door. If you are still deciding between a pull-on and a lace-up, see our pull-on vs lace-up work boots guide.

Red Wing Pecos models compared

These are the Pecos-style boots we carry. Every spec below comes from Red Wing's own product pages. A dash means Red Wing does not list it.

Model # Height Toe Sole / construction Waterproof Best for
1155 NailSeat 11 in. Soft toe Goodyear leather welt, nailed heel, Vibram Chemigum cork outsole – Ranch, shop and jobs with no safety-toe rule
2231 SuperSole 11 in. Steel toe, EH SuperSole welt, single-density urethane Mini Lug – Daily industrial and oilfield work
2230 SuperSole 11 in. Steel toe, EH SuperSole welt, direct-molded urethane Mini Lug Yes Wet locations and wash-down work
3505 SuperSole 2.0 11 in. Steel toe, EH, PR Dual-density SuperSole welt, Aztec outsole – Sites that require puncture resistance or CSA
8060 Pecos (Heritage) 11 in. Almond, no safety toe Goodyear leather welt, Brown Chemigum outsole – Western wear and everyday

The 3505 also carries CSA Grade 1 (ESR rated, PR) and a slip-resistant rating. The 1155 outsole is rated heat resistant to at least 475°F.

SuperSole vs NailSeat

SuperSole is Red Wing's urethane sole bonded to the boot. Red Wing describes the original as a single-density urethane sole that resists slipping, abrasion, cuts, oil and chemicals. The SuperSole 2.0 on the 3505 uses two densities: a softer inner layer for cushion and a tougher outer layer.

NailSeat is a leather-welted boot with a nailed heel seat. Red Wing says the nails cinch over to lock the heel in place, so the boot only comes off when you want it to. The 1155 pairs that with a Goodyear welt and a Vibram Chemigum cork sole.

In plain terms: SuperSole is the choice when you want a safety toe, EH and chemical resistance. NailSeat is the choice when you want a traditional leather-welt boot with a heat-resistant cork sole and no safety toe. Both are resoleable.

How Pecos boots should fit

We've fit boots in Elk City since 1980, and pull-ons fit differently than lace-ups. There are no laces to snug things up, so the boot itself has to hold your foot.

  • Instep first. The instep, the top of your foot, is what holds a pull-on in place. It should feel snug going in. If your foot slides in with no resistance, the boot is too big.
  • Some heel slip is normal. A new Pecos will lift at the heel a little when you walk. A small amount is expected while the sole is still stiff. If your heel pops out of the counter, go down a size or try a narrower width.
  • Toes need room. Your toes should not touch the end of the boot, especially in a steel toe. Stand up and walk when you try them on.
  • Expect a break-in. Full-grain leather softens and shapes to your foot with wear. Wear new boots for part of a day before a full shift.
  • Models fit differently. Red Wing builds these on different lasts: No. 72 for the 1155, 522 for the 2231, 696 for the 2230 and 3505, and No. 17 for the 8060. Your size in one may not be your size in another, so try the model you plan to buy.

If you can, come in and let us measure both feet. Call the store at (580) 225-7363 if you want to check a size before you drive over.

Which Pecos for which job

Oilfield

Most locations require a safety toe and EH. The 2231 and 2230 both have steel toes rated ASTM F2413-24 I/C, EH. Choose the 2230 if you work wet. Choose the 3505 if your company or customer requires puncture resistance or CSA approval.

Standing in oil-based mud is different. The mud breaks down the liner in waterproof leather boots, so we point mud crews to the Cordura Red Wing 2499 or the non-waterproof 2231. Our oilfield work boots guide explains why.

Ranch and farm

The 1155 NailSeat is a soft toe with a leather welt and a cork sole, which suits riding, feeding and shop work. The 8060 Pecos is the western option with an almond toe and low roper heel.

Concrete and wet work

Red Wing builds the SuperSole to resist oil and chemicals. For long days in standing water or wash-down areas, the waterproof 2230 is the one to start with.

Shop Red Wing Pecos boots at Circle A

These Pecos-style boots are in stock at Circle A Western and Outdoor, 3000 W 3rd St, Elk City, and on our site:

Related pull-ons: the Red Wing 2499 Cordura Pecos SuperSole (waterproof, steel toe, Cordura upper) and the Red Wing 4448 FlexForce 11" Aluminum Toe Waterproof Pull-On. You can also browse all Red Wing SuperSole boots or every Red Wing boot we carry.

Red Wing Pecos FAQ

What is a Red Wing Pecos boot?

The Pecos is Red Wing's 11-inch pull-on boot. Red Wing first made it as a roper-style cowboy boot, and many people, our store included, also use the name for Red Wing's 11-inch pull-on work boots such as the SuperSole and NailSeat.

Is the Red Wing 1155 a steel toe boot?

No. The Red Wing 1155 NailSeat is a soft toe boot. Red Wing lists it as slip resistant under ASTM F3445-24, with an outsole that resists melting at 475°F or higher.

What does NailSeat mean on a Red Wing boot?

NailSeat refers to nailed heel-seat construction. Nails cinch over to lock the heel in place, so the boot stays on until you take it off.

Are Red Wing Pecos boots waterproof?

Some are. The 2230 SuperSole uses Red Wing waterproofing, and the 2499 Cordura Pecos is waterproof too. Red Wing does not list waterproofing for the 2231, 3505, 1155 or 8060.

Can Red Wing Pecos boots be resoled?

Yes. Red Wing lists the 2231, 2230, 3505, 1155 and 8060 as resoleable.

Where are Red Wing Pecos boots made?

Red Wing lists the 2231, 3505, 1155 and 8060 as made in the USA, and the 2230 as made in the USA with imported materials.

Gear from this guide, in stock

Cart

Your cart is currently empty.

Start Shopping

Select options